Agilent Technologies E4418B User Manual page 160

3 Menu Reference
•
136
• Min Power
Press this softkey to enter the input power level that you want to
represent the 0 Vdc minimum output voltage of the Recorder Output.
Service
Press this softkey to access a menu which allows you to test and service
your power meter.
• Self Test
Press this softkey to access the power meter's self test menu.
• Instrument Self Test
Press this softkey to run a series of tests on the power meter. Refer
to "Instrument Self Test"
tests run.
• Confidence Check
Press this softkey to verify that the power meter makes an accurate
measurement of its 1 mW POWER REF output.
• Individual
Press this softkey to access a menu which allows you to select individual
self tests to be run.
Memory
■
Press this softkey to perform a ROM Checksum verification test, verify
the memory and that the correct amount of RAM is present.
Lithium Battery
■
Press this softkey to verify that the firmware checksum is still
resident in a battery- backed memory location.
Measure Assembly
■
Press this softkey to run a self test on the measurement assembly.
Refer to "Measurement Assembly"
information.
Calibrator
■
Press this softkey to make internal voltage measurements on the
50 MHz reference oscillator.
Keyboard
■
on page 96 for further information on the
on page 98 for further
E4418B Power Meter User's Guide