Presetting The Power Meter; Preset Conditions - Agilent Technologies E4419B User Manual

Power Meter Operation

Presetting the Power Meter

Presetting the Power Meter
This section details the power meter's preset conditions.
The GP-IB address, the data stored in the sensor calibration tables and
the zeroing and calibration data are not affected by a preset. The
calibration table selected is not affected.

Preset Conditions

The number of windows displayed is two.
dBm/W
Measurement units used is set to dBm.
Frequency
Cal Fac
• is set to 50 MHz.
A Freq
•
A Cal Fac
• is set to 50 MHz.
B Freq
• B Cal Fac
Meas
Setup
•
Input Select
Channel B in the lower window.
•
Display Format
•
Anlg Mtr Scaling
( ).
Min
•
Resolution 1 2 3 4
•
Limits Off/On
• is set to 90.000 dbm (
Limits
•
TTL Output Off/On
• Limits OVER UNDER EITHER
•
Fail O/P High Low
Rel
Offset
•
Rel Off/On
• Offset Off/On
2-70
is set to 100%.
is set to 100%.
is set to Channel A in the upper window and
is set to digital for both windows.
is set to 20.000 dBm (
is set to "3".
is set to "Off"
Max
is set to "Off".
is set to "OVER".
is set to "Low"
is set to "Off".
is set to "Off".
) and -70.000 dBm
Max
) and -90.000 dBm (
Min
Agilent E4419B User's Guide
).