Selecting a Sensor Calibration Table
You can select a sensor calibration table for use by pressing
Tables
any sensor calibration tables are currently selected. The "Sensor Tbls"
screen is displayed as shown in
Figure 2-4 "Sensor Tbls" Screen
Making the Measurement
To make the power measurement, you zero and calibrate the power meter,
then set it for the frequency of the signal you want to measure. The power
meter automatically selects the calibration factor from the sensor calibration
table.
1 Press
2 Press
3 The setting of the reference calibration factor is obtained from the sensor
4 Connect the power sensor to the POWER REF output.
E4418B Power Meter User's Guide
,
Sensor Cal Tables Table Off On
.
. During zeroing, which takes approximately 10 seconds, the wait
Zero
symbol is displayed.
calibration table and displayed under the
,
. The "State" field indicates if
Figure 2-
4.
Ref CF
Power Meter Operation
softkey.
2
,
45