Agilent Technologies E4418B User Manual page 157

E4418B Power Meter User's Guide
• Offset
Press this softkey to enter a channel offset in the range of –100 dB to
+100 dB. The default value is 0 dB. Use the
keys to change the value. To confirm your choice, press
can be used to compensate for a loss or gain. The offset is applied to the
measured power before the result is displayed.
automatically set to "On" when a value is entered using
to "Setting Channel Offsets"
• Range (Agilent E- Series power sensors or N8480 Series power sensors
(excluding Option CFT) only)
Press this softkey to set the range in which you require the power meter
to make the power measurement or set the power meter to autoranging.
Choose either "UPPER", "LOWER" or "AUTO" from the selection
available using the
to "Setting the Range"
• Limits
Press this softkey to access a menu which allows you to enter the upper
and lower measurement limits. Refer to
Limits" on page 70 for further information.
Limits Off On
■
Press this softkey to toggle between the test limits being on or off. The
default is "Off".
Max
■
Press this softkey to enter the upper measurement limit in the range
–150 dBm to 230 dBm. The default value is 90.00 dBm. Use the
, , and
choice, press the appropriate measurement units.
greater than Min
Min
■
Press this softkey to enter the lower measurement limit in the range
–150 dBm to 230 dBm. The default value is –90.00 dBm. Use the
, , and
choice, press the appropriate measurement units.
than Max .
Duty Cycle Off On
•
Press this softkey to toggle the duty cycle value on or off. The default is
"Off". The duty cycle value is set using
on page 63 for further information.
and keys. The default is "AUTO". Refer
on page 79 for further information.
keys to change the value. To confirm your
.
keys to change the value. To confirm your
Menu Reference
, , , and
dB
. This offset
Offset Off On
Offset
"Setting Measurement
Max must be
Min must be less
Duty Cycle
.
3
is
. Refer
,
,
133