Agilent Technologies E4418B User Manual page 81

There are ten frequency dependent offset tables named CUSTOM_A
through CUSTOM_J which do not contain any data when the power meter
is shipped from the factory.
You cannot delete any of the 10 existing frequency dependent offset tables
or create any additional tables. However, you can edit the 10 existing
tables. Each frequency dependent offset table can contain a maximum of
80 frequency points.
To edit a table:
1 Select one using the
2 To edit the parameter you currently have selected, press
3 To confirm your choice, press the appropriate softkey.
4 To add a new frequency dependent offset table entry, press
5 To remove a frequency dependent offset table entry, use the
E4418B Power Meter User's Guide
tables. When the table you want to edit is highlighted, press
The "Edit Offset" screen is displayed as shown in
page 56. In this screen, you can modify, add, and remove frequencies
and offset and also edit the table name. Use the
keys to move between the table name and its frequencies and
offsets.
A frequency in the range of 0.001 MHz to 999.999 GHz can be entered.
An offset in the range of 1% to 150% can be entered.
• The following rules apply to naming frequency dependent offset tables:
• The name must consist of no more than 12 characters.
• All characters must be upper or lower case alphabetic characters or
numeric (0- 9) or an underscore (_).
• No other characters are allowed.
• No spaces are allowed in the name.
power meter displays the data in a pop- up window. Modify this data (see
below) as desired.
• Use or
currently positioned.
• Use or
prompted for the frequency and offset. The entry is sorted by frequency.
, and keys to select the entry, press
frequency, the equivalent offset is also removed and vice versa.
or keys to scroll through the displayed
to modify the character on which the cursor is
to move to other characters.
Power Meter Operation
Edit Table
Figure 2- 7 on
, ,
. The
Change
. You are
Insert
,
. If you delete the
Delete
2
.
, and
,
57