Agilent Technologies E4418B User Manual page 152

3 Menu Reference
128
HP 437B
■
Press this softkey to select the Agilent 437B emulation mode. In this
mode, the power meter responds to the Agilent 437B programming
command set.
• Select Interface
Press this softkey to access a menu which allows you to select between
GPIB, RS232 and RS422 as the remote interface standard.
GPIB
■
Press this softkey to select the GPIB port for remote operation.
RS232
■
Press this softkey to select the serial port for remote operation using
the RS232 Standard.
RS422
■
Press this softkey to select the serial port for remote operation using
the RS422 Standard.
• Configure Interface
Press this softkey to access a menu which allows you to either configure
the GPIB interface or the serial interface (RS232/RS422).
GPIB
■
Press this softkey to access a menu which allows you to set the GPIB
address.
GPIB Addr
■
Press this softkey to set the GPIB address of your power meter
between 0 and 30. The default value is 13. A pop- up window
appears on the screen. Use the
keys to change the value. To confirm your choice, press
Refer to "GPIB Address"
Serial
■
Press this softkey to access a menu which allows you to set baud rate,
word size, parity, number of stop bits, pacing and echo for the serial
interface.
, ,
on page 80 for further information.
E4418B Power Meter User's Guide
, and
Enter .