The Rear Panel At A Glance - Agilent Technologies E4418B User Manual

1 Getting Started

The Rear Panel at a Glance

1 Channel A (Option 002 or 003 only)
2 Power Ref (Option 003 only)
3 Recorder Output
4 Power socket
5 Fuse
6 GPIB
7 RS232/422
16
1
9
The power reference output is a 50 Ω type- N connector. The output signal is
used for calibrating the sensor meter combination.
This output produces a DC voltage that corresponds to the power level of
the channel input. Refer to
information.
This power meter has an auto configuring power supply. This allows it to
operate over a range of voltages without manually being set to a certain
voltage.
An F3.15AH fuse is installed for all voltage supplies.
This connector allows the power meter to be controlled remotely using the
General Purpose Interface Bus.
This connector allows the power meter to be controlled remotely using
either the RS232 or RS422 serial interface standards.
2 3
N279
8
7
"Recorder Output"
4
5
6 10
on page 86 for further
E4418B Power Meter User's Guide