Agilent Technologies E4418B User Manual page 153

E4418B Power Meter User's Guide
Baud Rate
■
Press this key to set the serial interface baud rate. The default
value is 9600. A pop- up window appears on the screen giving a
range of values (50, 75, 110, 150, 300, 1200, 1800, 2000, 2400,
3600, 4800, 7200, 9600, 19.2K, 38.4K, 57.6K, or 115.2K).
Word Size
■
Press this softkey to set the serial interface word length. A pop- up
window appears on the screen giving a selection of seven or eight.
Stop Bits
■
Press this softkey to set the serial interface number of stop bits. A
pop- up window appears on the screen giving a selection of one or
two.
Parity
■
Press this softkey to enable or disable parity and set the parity
type for the serial interface. A pop- up window appears on the
screen allowing you to select from ODD, EVEN, ZERO, ONE or
NONE.
Pacing
■
Press this softkey to access a menu which allows you to enable or
disable various hardware and software pacing options.
Tx Pacing
◆
Press this softkey to toggle between enabling and disabling the
Xon/Xoff transmitter software handshake. When enabled
"Xon" is highlighted, otherwise "None" is highlighted.
Rx Pacing
◆
Press this softkey to toggle between enabling and disabling the
Xon/Xoff receiver software handshake. When enabled, "Xon"
is highlighted, otherwise "None" is highlighted.
RTS/CTS
◆
Press this softkey to obtain a pop- up window which allows you
to select one of the following:
OFF - Sets the RTS signal line permanently low.
ON - Sets the RTS signal line permanently high.
Menu Reference 3
129