Agilent Technologies E4418B User Manual page 106

2 Power Meter Operation
To set the serial interface parameters:
1 Press
2 To change the baud rate, press
3 To change the word size, press
4 To change the number of stop bits, press
5 To change the parity type, press
6 Press
7 Press
8 Press
9 Press
10 Press
11 Press
82
,
Remote Interface Configure Interface Serial
current settings for
shown under the softkeys.
the baud rate in a pop- up window. Change the setting by using the
and keys to run through the selection of baud rates
available. To confirm your choice, press
the word size in a pop- up window. Change the setting by using any of
the arrow keys to toggle between a word size of seven or eight. To
confirm your choice, press
displays the number of stop bits in a pop- up window. Change the
setting by using any of the arrow keys to toggle between a setting of
one or two. To confirm your choice, press
parity type in a pop- up window. Change the setting by using any of the
arrow keys to select from EVEN, ODD, ZERO, ONE, or NONE. To
confirm your choice, press
to access page 2 of 2. This page allows you to set echo off
and on and gives access to the pacing menu.
to toggle between off and on. When echo is on, all received
Echo
characters will be transmitted (echoed) back to the sender.
to access the pacing menu which allows you to enable or
Pacing
disable various software and hardware pacing options. Pacing will
prevent receiver overrun errors and is generally only required when
large amounts of data are being transferred (for example, cal tables).
to toggle between enabling and disabling the Xon/Xoff
Tx Pacing
transmitter software handshake. When enabled "Xon" is highlighted,
otherwise "None" is highlighted.
to toggle between enabling and disabling the Xon/Xoff
Rx Pacing
receiver software handshake. When enabled "Xon" is highlighted,
otherwise "None" is highlighted.
and use any of the arrow keys to select one of the
RTS/CTS
following from the pop- up menu:
OFF - Sets the RTS signal line permanently low.
,
,
Baud rate Word size Stop bits
Baud rate
Word size
.
Enter
Parity
.
Enter
,
, , and
. The power meter displays
.
Enter
. The power meter displays
. The power meter
Stop bits
.
Enter
. The power meter displays the
E4418B Power Meter User's Guide
. The
are
Parity