Agilent Technologies E4418B User Manual page 66

2 Power Meter Operation
5 The current setting of the reference calibration factor is displayed under
6 To confirm your choice, press
7 Press
8 Press
9 To confirm your choice, press
10 Connect the power sensor to the signal to be measured.
11 The measurement result is now displayed.
42
the softkey. To change this setting, press
Ref CF
displays the reference calibration factor in a pop- up window. Modify this
reference calibration factor (see below) as desired.
• Use or
positioned.
• Use or
to calibrate the power meter. During calibration, the wait symbol
Cal
is displayed. (The power meter automatically turns on the POWER REF
output.)
displayed under the
The power meter displays the calibration factor in a pop- up window. Modify
this calibration factor (see below) as desired.
• Use or
positioned.
• Use or
to modify the digit on which the cursor is currently
to move to other digits.
.
%
. The current setting of the calibration factor is
softkey. To change this setting, press
Cal Fac
to modify the digit on which the cursor is currently
to move to other digits.
.
%
. The power meter
Ref CF
E4418B Power Meter User's Guide
.
Cal Fac