Relocating/Storing The Fault Tolerant Server Series - NEC NovaScale R630 User Manual

RELOCATING/STORING THE FAULT TOLERANT SERVER SERIES

Follow the procedure below to relocate or store the server. (Users should not attempt to remove the rack-mountable
server from the rack assembly.)
Observe the following instructions to use the server safely. There are risks of
fire, personal injury, or property damage. See "PRECAUTIONS FOR SAFETY"
in Chapter 1 for details.
• Never attempt to lift the server only by yourself.
• Do not install the server in any place other than specified.
• Do not connect/disconnect any interface cable with the power cord of the
server plugged to a power source.
IMPORTANT:
If the server needs to be relocated/stored due to a change in the floor layout to a great extent, contact the
sales agent.
Make sure to make a backup copy of your valuable data in the hard disk, if any.
When moving the server with hard disks, make sure not to give a shock to the hard disks.
When storing the server, keep it under storing environment conditions (temperature: -10 to 55
20 to 80%, non-condensing).
1.
Take a floppy disk and a CD-ROM out of the server, if any.
2.
Power off the server.
3.
Unplug the power cord of the server from a power outlet.
4.
Remove all the cables from the server.
5.
Remove all the mounted CPU/IO modules.
6.
Remove the 4U chassis and the rails from the rack cabinet.
7.
Carry 4U chassis and CPU/IO modules separately.
8.
Protect the server with the shock-absorbing materials, and pack it securely.
IMPORTANT:
Check and adjust the system clock before operating the server again after relocating or storing it.
If the server and the built-in optional devices are moved from a cold place to a warm place in a short time,
condensation will occur and cause malfunctions and breakdown when these are used in such state. When you start
operating these equipments again after the transportation or the storage, make sure to wait for a sufficient period of
time to use them in the operating environment.
If the system clock goes out of alignment remarkably as time goes by, though the system clock adjustment is
performed, contact your sales agent.
CAUTION
6-10
umidity:
°C, h