Connect Rh Engine Wire Harness; Install No.1 Egr Cooler; Install Air Intake Chamber - Toyota 3VZ–FE Troubleshooting Manual

ENGINE TROUBLESHOOTING

20. CONNECT RH ENGINE WIRE HARNESS

(a) Connect the two clamps, and install the engine wire harness
with the four bolts.
(b) Connect the following connectors:
(1) Three injector connectors
(2) Engine coolant temp. sender gauge connector
(3) Oxygen sensor connector
(4) PS pump connector
(5) Oil pressure switch connector
(6) Engine oil level sensor connector
(7) A/C compressor connector
(8) Engine coolant temp. sensor connector (for hydraulic

21. INSTALL NO.1 EGR COOLER

Install a new gasket and the No.1 EGR cooler with the bolt
and two nuts.
Torque: 18 N m (185 kgf cm, 13 ft lbf)

22. INSTALL AIR INTAKE CHAMBER

(a) Using 8 mm hexagon wrench, install a new gasket and the air
intake chamber with the two bolts and nuts.
Uniformly tighten the bolts and nuts in several passes.
Torque: 43 N m (440 kgf cm, 32 ft lbf)
(b) Connect the two ground straps with the nut.
Torque: 13 N m (130 kgf cm, 9 ft lbf)
(c) Connect the hydraulic pressure pipe with the bolt.
Torque: 20 N m (200 kgf cm, 14 ft lbf)
(d) Install the air intake chamber stay.
Torque: 39 N m (400 kgf cm, 29 ft lbf)
(e) Install the No.1 engine hanger.
Torque: 39 N m (400 kgf cm, 29 ft lbf)
(f) Connect the PS ACV with the nut.
– ENGINE MECHANICAL
cooling fan)
EG–83