Install Rear End Plate; Install Flywheel - Toyota 3VZ–FE Troubleshooting Manual

EG–128
ENGINE TROUBLESHOOTING
11. INSTALL DISTRIBUTOR (See IG section)
12. REMOVE ENGINE STAND

13. INSTALL REAR END PLATE

14. (M/T)
(a) Apply adhesive to two or three threads of the mount bolt end.
(b) Install the flywheel on the crankshaft.
(c) Install and uniformly tighten the eight mount bolts in several
15. (A/T)
16. (M/T)
– ENGINE MECHANICAL
Install the end plate with the bolt.
Torque: 8.3 N m (85 kgf cm, 74 in. lbf)

INSTALL FLYWHEEL

Adhesive:
Part No. 08833–00070, THREE BOND 1324 or equivalent
passes, in the sequence shown.
Torque: 83 N m (850 kgf cm, 61 ft lbf)
INSTALL DRIVE PLATE (See procedure step 14)
Torque: 83 N m (850 kgf cm, 61 ft lbf)
INSTALL CLUTCH DISC AND COVER