Reinstall Cylinder Head Covers; Reconnect Rh Engine Wire Harness - Toyota 3VZ–FE Troubleshooting Manual

EG–18
ENGINE TROUBLESHOOTING
(g) Recheck the valve clearance.

22. REINSTALL CYLINDER HEAD COVERS

(a) Apply seal packing to the cylinder heads as shown in the
(b) Install the gasket to the cylinder head cover.
(c) Install the cylinder head cover with the six seal washers and
23. RECONNECT HIGH–TENSION CORDS TO SPARK

24. RECONNECT RH ENGINE WIRE HARNESS

(a) Connect the two clamps of the RH engine wire harness and
(b) Connect the following connectors:
– ENGINE MECHANICAL
Place a new adjusting shim on the valve lifter.
Press down the valve lifter with SST (A), and remove SST
(B).
SST 09248–55020(09248–05011, 09248–05021)
illustration.
Seal packing:
Part No.08826–00080 or equivalent
nuts. Uniformly tighten the nuts in several passes. Install the
two cylinder head covers.
Torque: 5.9 N m (60 kgf cm, 52 in. lbf)
PLUGS
install the wire harness with the two bolts.
(1) Three injector connectors
(2) Engine coolant temperature sender gauge connector
(3) Oxygen sensor connector
(4) PS pump connector