Inspect For Water Leaks - Toyota 3VZ–FE Troubleshooting Manual

EG–260
ENGINE TROUBLESHOOTING
(b) Check the lock plate height (H) after completing the caulking.
6.
(a) Tighten the drain plug.
(b) Plug the inlet and outlet pipes of the radiator with SST.
(c) Using a radiator cap tester, apply pressure to the radiator.
(d) Inspect for water leaks.
– COOLING SYSTEM
HINT:
Do not stake the areas protruding around the pipes,
brackets or tank ribs.
The points shown in the illustration and oil cooler near here
(A/T) cannot be staked with the SST. Use a plier or like
object and be careful not to damage the core plates.
Plate height:
7.75–8.25 mm (0.305–0.325 in.)
If not within the specified height, adjust the stopper bolt of the
handle again and perform the caulking again.

INSPECT FOR WATER LEAKS

SST 09230–01010
Torque: 177 kPa (1.8 kgf/cm
2
, 26 psi)