Connect Fr Engine Mounting Insulator; Install Engine Mounting Absorber - Toyota 3VZ–FE Troubleshooting Manual

EG–130
ENGINE TROUBLESHOOTING
6.
(a) Temporarily install the engine moving control rod and No.2
(b) Tighten the three bolts in the sequence shown.
(c) Install the RH mounting stays with the three bolts and nut.
7.
8.
– ENGINE MECHANICAL
INSTALL NO.2 ENGINE MOUNTING BRACKET AND
ENGINE MOVING CONTROL ROD
engine mounting bracket with the three bolts in the sequence
shown.
Torque: 64 N m (650 kgf cm, 47 ft lbf)
Bolt (A)
Torque: 31 N m (320 kgf cm, 23 ft lbf)
Bolt (B)
Torque: 62 N m (630 kgf cm, 46 ft lbf)

CONNECT FR ENGINE MOUNTING INSULATOR

Connect the mounting insulator with the three bolts.
Torque: 80 N m (820 kgf cm, 59 ft lbf)

INSTALL ENGINE MOUNTING ABSORBER

Install the engine mounting absorber with the four bolts.
Torque: 48 N m (490 kgf cm, 35 ft lbf)