EG–36
ENGINE TROUBLESHOOTING
27. REMOVE TIMING BELT
28. REMOVE NO.1 IDLER PULLEY
29. REMOVE CRANKSHAFT TIMING PULLEY
–
ENGINE MECHANICAL
HINT (Re–using timing belt): If the installation marks have
disappeared, place a new installation mark on the timing belt
to match the drilled mark of the crankshaft timing pulley.
Using a 10 mm hexagon wrench, remove the bolt, idler pulley
and plate washer.
If the pulley cannot be removed by hand, use two screw–driv-
ers.
HINT: Position shop rags as shown to prevent damage.