Connect Hydraulic Motor Pressure Pipe; Connect Ground Straps - Toyota 3VZ–FE Troubleshooting Manual

EG–196
ENGINE TROUBLESHOOTING
9.
10. INSTALL EGR PIPE
11. INSTALL NO.1 ENGINE HANGER AND AIR INTAKE
(a) Install the air intake chamber stay with the two bolts.
(b) Install the No.1 engine hanger with the two bolts.
12. CONNECT COLD START INJECTOR PIPE (NO. 2 FUEL
13. CONNECT COLD START INJECTOR CONNECTOR

14. CONNECT GROUND STRAPS

15. CONNECT HOSES
(a) Brake booster vacuum hose
(b) PS air hose
(c) PCV hose
(d) IACV vacuum hose
16. INSTALL EMISSION CONTROL VALVE SET
(a) Install the emission control valve set with the two bolts.
(b) Connect the two VSV connectors.
(c) Connect the two vacuum hoses of the IACV VSV.
(d) Connect the two vacuum hoses of the fuel pressure control
(e) Connect the EGR gas temp. sensor connector clamp to the
– SFI SYSTEM

CONNECT HYDRAULIC MOTOR PRESSURE PIPE

Connect the hydraulic pressure pipe to the air intake cham-
ber with the bolt.
Install a new gasket, sleeve ball and the EGR pipe with the
two bolts and union nut.
Bolt
Torque: 18 N m (185 kgf cm, 13 ft lbf)
Union nut
Torque: 78 N m (800 kgf cm, 58 ft lbf)
CHAMBER STAY
Torque: 39 N m (400 kgf cm, 29 ft lbf)
Torque: 39 N m (400 kgf cm, 29 ft lbf)
PIPE)
Connect the injector pipe with two new gaskets and union
bolt.
Torque: 15 N m (150 kgf cm, 11 ft lbf)
Connect the two ground straps with the nut.
Torque: 13 N m (130 kgf cm, 9 ft lbf)
VSV.
emission control valve set.