4
Check voltage between terminals VTA and E2 of ECM.
NG
5
Check resistance between terminals 3 and 1 of throttle position sensor.
OK
Check for open and short in harness and connector between ECM and throttle position sensor
6
(See page IN–27).
OK
Check and replace ECM.
ENGINE TROUBLESHOOTING
P
C
OK
Check for momentary interruption (See page EG–333).
OK
P
C
OK
Replace throttle position sensor.
NG
Repair or replace harness or connector.
NG
–
CIRCUIT INSPECTION
Turn ignition switch ON.
Measure voltage between terminals VTA and E2 of
ECM.
Disconnect the throttle position sensor connector.
Measure the resistance between terminals 3 and 1 of
throttle position sensor.
EG–395