ENGINE TROUBLESHOOTING
(b) Torque the three bolts in the sequence shown.
Torque: 64 N m (650 kgf cm, 47 ft lbf)
20. INSTALL RH ENGINE MOUNTING STAY
Install the mounting stay with the bolt and nut.
Torque: 31 N m (320 kgf cm, 23 ft lbf)
21. CONNECT CONNECTOR TO GROUND WIRE ON RH
FENDER APRON
22. INSTALL RH FENDER APRON SEAL
23. INSTALL RH FRONT WHEEL
24. INSTALL AND ADJUST PS DRIVE BELT
Install the drive belt with the pivot and adjusting bolts.
Drive belt tension:
New belt
Used belt
25. INSTALL GENERATOR DRIVE BELT
Adjust the drive belt. (See CH section)
Drive belt tension:
New belt
Used belt
–
ENGINE MECHANICAL
150–185 lb
115 20 lb
175 5 lb
115 20 lb
EG–45