Fluid Level Inspection; Inspect Fluid Level - Toyota 3VZ–FE Troubleshooting Manual

EG–264
ENGINE TROUBLESHOOTING
ON–VEHICLE INSPECTION

FLUID LEVEL INSPECTION

1.
2.
(a) Using SST, connect terminals OP1 and E1 of the data link
(b) Keep the engine speed at 2,000 rpm until the fluid
(c) Check that there is no foaming and emulsification of the fluid
(d) Measure the fluid level with the engine running.
(e) Stop the engine, and measure the fluid level.
(f)
(g) Check the fluid level.
(h) Remove the SST from the data link connector 1.
– COOLING SYSTEM
KEEP VEHICLE LEVEL

INSPECT FLUID LEVEL

connector 1.
SST 09843–18020
temperature reaches the specified temperature.
Fluid temperature:
70–90 C (158–195 F)
in the reservoir tank.
Subtract (d) from (e).
Maximum stroke:
5 mm (0.20 in.)
If low, add fluid.
Fluid:
ATF DEXRON II
HINT: Check that fluid level is within the "HOT" level on reser-
voir tank. If the fluid is cold, check that it is within the "COLD"
level on the tank.
SST 09843–19020
EG0A9–01