EG–274
ENGINE TROUBLESHOOTING
HYDRAULIC MOTOR ASSEMBLY
(See page EG–270)
1.
2.
3.
4.
5.
6.
(a) Install a new O–ring to the motor housing groove.
(b) Install the motor cover with the four bolts.
–
COOLING SYSTEM
HINT:
Throughly clean all parts to be assembled.
Before installing the parts, apply new fluid to all sliding and
rotating surfaces.
MOUNT MOTOR HOUSING
Slightly mount the motor housing in a vise.
NOTICE: Be careful not to damage the motor housing.
INSTALL FRONT THRUST WASHER
INSTALL DRIVEN AND DRIVE ROTORS
Install the drive and driven rotors with the dot mark facing up-
ward.
INSTALL DRIVE SHAFT
INSTALL REAR THRUST WASHER
INSTALL MOTOR COVER
Torque: 28 N m (200 kgf cm, 21 ft lbf)
EG0AJ–01