Quick Setup "Commissioning - Endress+Hauser Proline Prosonic Flow 93T Portable Operating Instructions Manual

Proline Prosonic Flow 93T Portable
!
Endress+Hauser
6.3.2

Quick Setup "Commissioning"

All the device parameters important for standard measuring mode, as well as additional functions,
can be configured easily and quickly using the Quick Setup menu.
E
XXX.XXX.XX
Esc
- +
E
HOME-POSITION
m
Selection
Volume flow
System units
Unit
Volume Flow
Unit
Totalizer
n
Configure another unit?
YES
Automatical configuration
of the display
Fig. 42: Quick Setup "Commissioning"
Note!
• The display returns to the function SETUP COMMISSIONING (1002) if you press the ESC key
combination during parameter interrogation.
• If you answer YES to the question regarding the "Automatic configuration of the display", the
display lines are assigned as follows:
– Main line = volume flow
– Additional line = totalizer 1
– Information line = operating/system condition
m Only units not yet configured in the current Quick Setup are offered for selection in each cycle. The volume unit is
derived from the volume flow unit.
n The "YES" option remains visible until all the units have been configured.
"NO" is the only option displayed when no further units are available.
o Only outputs not yet configured in the current Quick Setup are offered for selection in each cycle.
B
+ +
+ E
Quick Setup
Commission
Language
Presetting
System Units
Temperature Viscosity
0423
0402 0422
Unit Unit
Temperature Viscosity
3001
YES
Autom. Configuration of the display?
Commissioning
1002
QS
2000
Length Velocity Quit
0424 0425
Unit Unit
Length Velocity
NO
NO
Current configuration
of the display persists
A0015474-en
43