Application-Specific Commissioning; Quick Setup "Commissioning - Endress+Hauser PROFIBUS PA Proline Promass 80 Operating Instructions Manual

Proline Promass 80 PROFIBUS PA
!
Endress+Hauser
6.4

Application-specific commissioning

6.4.1

Quick Setup "Commissioning"

If the measuring device is equipped with a local display, all device-specific parameters important for
standard measuring operation can be configured easily and quickly using the "Commissioning"
Quick Setup menu (Fig. 31).
The individual parameters and functions must be configured via the configuration program on meas-
uring devices which do not have a local display.
+ +
E
XXX.XXX.XX
Esc
- +
E
HOME-POSITION
Mass flow
Unit
Mass flow
Unit
Totalizer
Fig. 31: Quick Setup "Commissioning" (only with local display)
L
m Selecting DELIVERY SETTINGS returns each selected unit to the factory setting.
Selecting ACTUAL SETTINGS applies the units you have set previously.
n Only units not yet configured in the current Setup are offered for selection in each cycle. The unit for mass, volume
and corrected volume is derived from the corresponding flow unit.
o The "YES" option remains visible until all the units have been configured. "NO" is the only option displayed when
no further units are available.
p The "automatic parameterization of the display" option contains the following
YES: line 1 = mass flow; line 2 = totalizer 1
NO: The existing (selected) settings remain.
Note!
• The display returns to the cell QUICK SETUP COMMISSION if you press the ESC key combina-
tion during parameter interrogation. The stored parameters remain valid.
Quick Setup
E
+
Quick Setup
Commission
Language
Pre-setting
m
Selection pre-settings
Deliver Settings y
n
Selection System Units
Volume flow Corr. Vol. flow Density
Unit Unit
Volume flow Corr. Vol. flow Density
Unit Unit
Totalizer Ref. Density
Fix
Ref. Density
o
Configuration another unit ?
Yes
Measuring
Mode
Automatically configuration display ?
Yes
Automatically
p
parameterization
of the display
6 Commissioning
Actual Settings
Temperature Quit
Unit Unit
Temperature
No
No
basic settings/factory settings:
A0004749-EN
63