Quick Setup; Quick-Setup "Commissioning - Endress+Hauser Proline Promag 50 Operating Instructions Manual

Proline Promag 50 PROFIBUS DP/PA
!
!
Endress+Hauser
6.2

Quick Setup

A Quick Setup guides you through the local display to the functions of the measuring device that
have to be configured for the task in question. The following Quick Setups are available for rapid
measuring device commissioning and to establish the cyclic data transfer between the PROFIBUS
master and the measuring device (slave):
• Quick Setup "Commissioning" → Page 73 (next section)
• Quick Setup "Communication" → Page 74
Note!
In the case of measuring devices without a local display, the individual parameters and functions
must be configured via a configuration program, (ToF Tool – Fieldtool Package, FieldCare).
6.2.1

Quick-Setup "Commissioning"

This Quick Setup menu guides you systematically through the setup procedure for all the major
device functions that have to be configured for standard measuring operation.
XXX.XXX.XX
Esc
-
HOME-POSITION
For the Quick Setup "Commissioning", only settings have to be made in the functions shown in the
graphic above.
Note!
When you run through the Quick Setup another function or option is displayed ("Select Output"
option) but this should not be taken into account. Settings in this function are not processed further
by the measuring system.
O
F
+
E
Commission
Volume Flow
Commissioning
Quick Setup
F
Setup
Language
Pre-Setting
Unit
Unit to Bus
Select
Output
F06-50PBxxxx-19-xx-xx-en-000
73