Endress+Hauser Proline Prosonic Flow 93T Portable Operating Instructions Manual page 42

Commissioning
!
42
Note!
• The installation distances can also be determined via the Applicator online tool  ä 15.
• The display returns to the function SETUP SENSOR (1001) if you press the ESC key combination
during parameter interrogation.
m
The necessary installation distances are determined with the CLAMP ON option.
n
The INSERTION option is not supported by the Prosonic Flow 93T sensor.
o
The SOUND VELOCITY LIQUID option is only needed for the DDU18 sensor.
"Save?" prompt:
• YES = The value measured during Quick Setup is accepted in the appropriate function.
• NO = The measurement is discarded and the original value remains.
p
The SOUND VELOCITY PIPE option is only needed for the DDU18 sensor.
"Save?" prompt:
• YES = The value measured during Quick Setup is accepted in the appropriate function.
• NO = The measurement is discarded and the original value remains.
q
The WALL THICKNESS option is only needed for the DDU20 sensor.
"Save?" prompt:
• YES = The value measured during Quick Setup is accepted in the appropriate function.
• NO = The measurement is discarded and the original value remains.
r
The SOUND VELOCITY LINER (6529) only appears if:
• The LINER MATERIAL is selected to something other than NONE. (6880)
s
The LINER THICKNESS (6530) only appears if:
• The LINER MATERIAL is selected to something other than NONE. (6880)
t
The POSITION SENSOR function (6884) only appears if:
• The CLAMP ON option is selected in the MEASUREMENT function (6880)
and
• Two traverses are selected in the SENSOR CONFIGURATION function (6882)
u
The WIRE LENGTH function (6885) only appears if:
• The CLAMP ON option is selected in the MEASUREMENT function (6880)
and
• One traverse is selected in the SENSOR CONFIGURATION function (6882)
Proline Prosonic Flow 93T Portable
Endress+Hauser