Lenovo HX1310 Installation And Service Manual page 852

• W.3808002 An error occurred while saving UEFI settings to the IMM. Error Updating System
Configuration to IMM
Explanation:
Severity
Warning
User Response
Complete the following steps:
1. Use the Setup Utility to verify and save the settings (which will recover the settings).
2. Reset the IMM from the CMM.
3. Use CMM to remove auxiliary power from the compute node. This will reboot the compute node.
4. Check the IBM support site for an applicable service bulletin or firmware update that applies to
this error.
5. Update the IMM Firmware.
6. Use CMOS clear jumper to clear CMOS
7. (Trained service technician only) Replace the system board.
• W.3808003 Unable to retrieve the system configuration from the IMM. Error Retrieving System
Configuration from IMM
Explanation:
Severity
Warning
User Response
Complete the following steps:
1. Use the Setup Utility to verify and save the settings (which will recover the settings).
2. Reset the IMM from the CMM.
3. Use CMM to remove auxiliary power from the compute node. This will reboot the compute node.
4. Check the IBM support site for an applicable service bulletin or firmware update that applies to
this error.
5. Update the IMM Firmware.
6. Use CMOS clear jumper to clear CMOS
7. (Trained service technician only) Replace the system board.
• W.3818005 The CRTM flash driver could not successfully flash the staging area. The update
was aborted CRTM Update Aborted
Explanation:
Severity
Warning
User Response
Complete the following steps:
1. Continue booting the system. If system does not reset, manually reset the system.
838
HX1310, HX2310-E, HX3310, HX3310-F Installation and Service Guide