Table of Contents
Advertisement
Step 5.
Locate the coin-cell battery on the system board.
Figure 61. Location of the coin-cell battery on system board
a.
If there is a rubber cover on the battery holder, use your fingers to lift the battery cover from
the battery connector.
b.
Use one finger to tilt the battery horizontally out of its socket, pushing it away from the socket.
Attention: Neither tilt nor push the battery by using excessive force.
Figure 62. Coin-cell battery removal
c.
Use your thumb and index finger to lift the battery from the socket.
Attention: Do not lift the battery by using excessive force. Failing to remove the battery
properly may damage the socket on the system board. Any damage to the socket may require
replacing the system board.
.
Chapter 5
Removing and replacing components
Coin-cell battery
139
Advertisement
Table of Contents
Troubleshooting
