Table of Contents
Advertisement
Replacing the operator information panel assembly
Use this information to replace the operator information panel assembly.
To install the operator information panel, complete the following steps:
Step 1.
Read the safety information that begins on "Safety" on page v and "Installation guidelines" on
page 100.
Step 2.
Install the operator information panel assembly into the media cage.
Figure 72. Operator information panel assembly installation into media cage
Step 3.
Carefully push the media cage back into the chassis (see "Replacing the media cage" on page
143). Remember to reconnect the cables that were removed from the system board.
Step 4.
Reconnect the operator information panel assembly cable to the operator information panel
assembly.
Step 5.
Reinstall the cover (see "Replacing the cover" on page 105).
Step 6.
Slide the server into the rack.
Step 7.
Reconnect the power cords and any cables that you removed.
Step 8.
Turn on the peripheral devices and the server.
Removing the LCD system information display panel
Use this information to remove the LCD system information display panel.
To remove the LCD system information display panel, complete the following steps:
Step 1.
Read the safety information that begins on "Safety" on page v and "Installation guidelines" on
page 100.
Operator information panel
.
Chapter 5
Removing and replacing components
149
Advertisement
Table of Contents
Troubleshooting
