Table of Contents
Advertisement
Step 6.
Locate the coin-cell battery connector on the system board.
Figure 63. Location of the coin-cell battery connector on system board
a.
Tilt the battery so that you can insert it into the socket on the side opposite the battery clip.
Figure 64. Coin-cell battery installation
b.
Press the battery down into the socket until it clicks into place. Make sure that the battery clip
holds the battery securely.
c.
If you removed a rubber cover from the battery holder, use your fingers to install the battery
cover on top of the battery connector.
Step 7.
Reinstall PCI riser-card assembly 1 (see "Replacing a PCI riser-card assembly" on page 121), if
necessary.
Step 8.
Reinstall the cover (see "Replacing the cover" on page 105).
Step 9.
Slide the server into the rack.
.
Chapter 5
Removing and replacing components
Coin-cell battery
141
Advertisement
Table of Contents
Troubleshooting
