Lenovo HX1310 Installation And Service Manual page 185

Step 13. Loosen the two thumbscrews (one is near PCI slot 1 and one is near PCI slot 2).
Figure 104. Thumbscrews disengagement
Step 14. Grasp the system board handles and slide the system board toward the front of the server until it
stops.
Note: Make sure that the system board disengages from all system-board standoffs.
Step 15. Slightly push the system board toward the hot-swap fans; then, grasp the system board handles
and carefully lift it up from the chassis, being careful not to damage any surrounding components.
Figure 105. System board removal
Step 16. Remove the socket covers from the microprocessor sockets on the new system board and place
them on the microprocessor sockets of the old system board that you are removing.
Step 17. If you are instructed to return the system board, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.
System board handle
System board handle
System board handle
System board handle
Thumbscrew
Thumbscrew
Thumbscrew
.
Chapter 5 Removing and replacing components
171