Lenovo HX1310 Installation And Service Manual page 836

• I.1800F A processor family mismatch has been detected for one or more processor packages.
Processors have mismatched Family
Explanation:
Severity
Error
User Response
Complete the following steps:
1. Verify that matching processors are installed in the correct processor sockets. Correct any
mismatch found.
2. Check the IBM support site for an applicable service bulletin or firmware update that applies to
this processor error.
3. (Trained technician only)Replace the system board
• I.18010 A processor stepping mismatch has been detected for one or more processor packages.
Processors of the same model have mismatched Stepping ID
Explanation:
Severity
Error
User Response
Complete the following steps:
1. Verify that matching processors are installed in the correct processor sockets. Correct any
mismatch found.
2. Check the IBM support site for an applicable service bulletin or firmware update that applies to
this processor error.
3. (Trained technician only)Replace the system board
• I.2018002 The device found at Bus [arg1] Device [arg2] Function [arg3] could not be configured
due to resource constraints. The Vendor ID for the device is [arg4] and the Device ID is [arg5].
OUT_OF_RESOURCES (PCI Option ROM)
Explanation:
Severity
Info
User Response
Complete the following steps:
1. If this PCIe device and/or any attached cables were recently installed, moved, serviced or
upgraded, reseat the adapter and any attached cables.
2. Check IBM support site for any applicable service bulletin or UEFI or adapter firmware update
that applies to this error. NOTE: It may be necessary to disable unused option ROMs from
UEFI F1 setup or ToolsCenter Suite CLI or using adapter manufacturer utilities so that adapter
firmware can be updated.
3. Move the adapter to a different slot. If a slot is not available or error recurs, replace the adapter.
822
HX1310, HX2310-E, HX3310, HX3310-F Installation and Service Guide