Lenovo HX1310 Installation And Service Manual page 128

2R = dual-rank
4R = quad-rank
– xff is the device organization (bit width)
x4 = x4 organization (4 DQ lines per SDRAM)
x8 = x8 organization
x16 = x16 organization
– v is the SDRAM and support component supply voltage (VDD)
• Blank = 1.2 V specified
– wwwww is the DIMM bandwidth, in MBps
12800 = 12.80 GBps (DDR4-1600 SDRAMs, 8-byte primary data bus)
14900 = 14.93 GBps (DDR4-1866 SDRAMs, 8-byte primary data bus)
17000 = 17.00 GBps (DDR4-2133 SDRAMs, 8-byte primary data bus)
19200 = 19.20 GBps (DDR4-2400 SDRAMs, 8-byte primary data bus)
– m is the DIMM type
L = Load Reduction DIMM (LRDIMM)
R = Registered DIMM (RDIMM)
– aa is the CAS latency, in clocks at maximum operating frequency
– bb is the JEDEC SPD Revision Encoding and Additions level
– cc is the reference design file for the design of the DIMM
– d is the revision number of the reference design of the DIMM
Note: To determine the type of a DIMM, see the label on the DIMM. The information on the label is in
the format xxxxx nRxxx PC3v-xxxxxx-xx-xx-xxx. The numeral in the sixth numerical position indicates
whether the DIMM is single-rank (n=1), dual-rank (n=2), or quad-rank (n=4).
• The following rules apply to DDR4 RDIMM speed as it relates to the number of RDIMMs in a channel:
– When you install 1 RDIMM per channel, the memory runs at 2400 MHz.
– When you install 2 RDIMMs per channel, the memory runs at 2400 MHz.
– When you install 3 RDIMMs per channel, the memory may run at 1866 MHz.
– All channels in a server run at the fastest common frequency.
– Do not install registered, unbuffered, and load reduction DIMMs in the same server.
• The maximum memory speed is determined by the combination of the microprocessor, DIMM speed,
DIMM type, Operating Modes in UEFI settings, and the number of DIMMs installed in each channel.
• In two-DIMM-per-channel configuration, the server automatically operates with a maximum memory
speed of up to 2400 MHz when the following condition is met:
– Two 1.35 V dual-rank RDIMMs are installed in the same channel. In the Setup Utility, Memory speed is
set to Max performance and LV-DIMM power is set to Enhance performance mode. The 1.35 V
RDIMMs will function at 1.5 V.
• The server supports a maximum of 24 dual-rank RDIMMs or 24 quad-rank LRDIMMs.
• The following table shows an example of the maximum amount of memory that you can install using
RDIMMs:
114
HX1310, HX2310-E, HX3310, HX3310-F Installation and Service Guide