Removing A Memory Module - Lenovo HX1310 Installation And Service Manual

• Check the instructions that come with the drive to determine whether you have to set any switches or
jumpers on the drive. If you are installing a SAS or SATA hard disk drive, be sure to set the SAS or
SATA ID for that device.
• The hot-swap server models support up to eight 2.5-inch hot-swap SAS or SATA hard disk drives.
• The electromagnetic interference (EMI) integrity and cooling of the server are protected by having all bays
and PCI and PCI Express slots covered or occupied. When you install a drive, PCI, or PCI Express
adapter, save the EMC shield and filler panel from the bay or PCI or PCI Express adapter slot cover in the
event that you later remove the device.
• For a complete list of supported optional devices for the server, see http://www.lenovo.com/
serverproven/.
To install a hot-swap SAS or SATA hard disk drive, complete the following steps:
Note: If you have only one hard disk drive, you must install it in the bay 0 (upper-left).
Step 1. Read the safety information that begins on "Safety" on page v and "Installation guidelines" on
page 100.
Step 2. Remove the filler panel from the empty drive bay. Keep the filler panel in a safe place.
Step 3. Touch the static-protective package that contains the drive to any unpainted metal surface on the
server; then, remove the drive from the package and place it on a static-protective surface.
Step 4. Install the hard disk drive in the drive bay:
a. Make sure that the tray handle is in the open (unlocked) position.
b. Align the drive with the guide rails in the bay.
Figure 39. Hot-swap hard disk drive installation
c. Gently push the drive into the bay until the drive stops.
d. Rotate the tray handle to the closed (locked) position.
e. Check the hard disk drive status LED to verify that the hard disk drive is operating correctly. If
the yellow hard disk drive status LED of a drive is lit continuously, that drive is faulty and must
be replaced. If the green hard disk drive activity LED is flashing, the drive is being accessed.
Step 5. If you are installing additional hot-swap hard disk drives, do so now.
Step 6. Turn on the peripheral devices and the server.

Removing a memory module

Use this information to remove a memory module.
To remove a dual inline memory module (DIMM), complete the following steps:
112
HX1310, HX2310-E, HX3310, HX3310-F Installation and Service Guide
2.5-inch hot-swap
hard disk drive
Drive handle