Lenovo HX1310 Installation And Service Manual page 96

Step 4. Locate the UEFI boot backup jumper (J13) on the system board.
UEFI boot backup
jumper (J13)
Clear CMOS jumper (J11)
Figure 22. UEFI boot backup jumper (J13) location
Step 5. Move the UEFI boot backup jumper (J13) from pins 1 and 2 to pins 2 and 3 to enable the UEFI
recovery mode.
Step 6. Reinstall the server cover; then, reconnect all power cords.
Step 7. Restart the server. The system begins the power-on self-test (POST).
Step 8. Boot the server to an operating system that is supported by the firmware update package that
you downloaded.
Step 9. Perform the firmware update by following the instructions that are in the firmware update package
readme file.
Step 10. Turn off the server and disconnect all power cords and external cables, and then remove the
cover (see "Removing the cover" on page 104).
Step 11. Move the UEFI boot backup jumper (J13) from pins 2 and 3 back to the primary position (pins 1
and 2).
Step 12. Reinstall the cover (see "Replacing the cover" on page 105).
Step 13. Reconnect the power cord and any cables that you removed.
Step 14. Restart the server. The system begins the power-on self-test (POST). If this does not recover the
primary bank, continue with the following steps.
Step 15. Remove the cover (see "Removing the cover" on page 104).
Step 16. Reset the CMOS by removing the coin-cell battery (see "Removing the coin-cell battery" on page
137).
Step 17. Leave the coin-cell battery out of the server for approximately 5 to 15 minutes.
Step 18. Reinstall the coin-cell battery (see "Replacing the coin-cell battery" on page 140).
Step 19. Reinstall the cover (see "Replacing the cover" on page 105).
Step 20. Reconnect the power cord and any cables that you removed.
82
HX1310, HX2310-E, HX3310, HX3310-F Installation and Service Guide
1
2
3
3
2
1
On
System TPM physical
presence switch (SW11)
NMI button
Off
On
Off
2
1
SW3 switch
block
8 7 6 5 4 3 2 1