Rear View - Lenovo HX1310 Installation And Service Manual

– IMM hostname
– IMM dedicated MAC address
Note: Only the MAC address that is currently in use is displayed (dedicated or shared)
– IMM shared MAC address
– IP v4 information
– IP v6 address
• System environmental information:
– Ambient temperature
– CPU temperature
– AC input voltage
– Estimated power consumption

Rear view

The following illustrations show the connectors on the rear of the server.
Figure 11. Rear view (HX3310 shown)
• PCI slot 1: low-profile PCI Express adapter (NIC) – optional on HX1310 and HX2310-E, standard
on other models
• PCI slot 2: option second PCI Express adapter (NIC) – only on HX3310 and HX3310-F
• PCI slot 3: empty
• Ethernet connectors: Use either of these connectors to connect the server to a network.
• System-management Ethernet connector: Use this connector to connect the server to a network for
full systems-management information control. This connector is used only by the integrated management
module (IMM2.1). A dedicated management network provides additional security by physically separating
the management network traffic from the production network. In shared mode, depending on the network
environment, the IMM might disconnect from the network for a short time when the server restarts. You
can use the Setup Utility to configure the server to use a dedicated systems management network
or a shared network.
• USB connectors: Connect a USB device, such as a USB mouse or keyboard to any of these connectors.
• NMI button: Press this button to force a nonmaskable interrupt to the microprocessor. It allows you to
blue screen the server and take a memory dump (use this button only when directed by the Lenovo
service support). You might have to use a pen or the end of a straightened paper clip to press the button.
The NMI button is in the lower left-hand corner on the rear of the server.
18
HX1310, HX2310-E, HX3310, HX3310-F Installation and Service Guide