Lenovo HX1310 Installation And Service Manual page 171

• Do not allow the thermal grease on the microprocessor and heat sink to come in contact with anything.
Contact with any surface can contaminate the thermal grease and the microprocessor socket.
• Do not use any tools or sharp objects to lift the locking levers on the microprocessor socket. Doing so
might result in permanent damage to the system board.
• Each microprocessor socket must always contain either a socket cover or a microprocessor and heat sink.
• Be sure to use only the installation tools provided with the new microprocessor to remove or install
the microprocessor. Do not use any other tool.
• When installing multiple microprocessors, open one microprocessor socket at a time to avoid damaging
other microprocessor socket contacts.
• The microprocessor installation tool has the microprocessor installed on the tool, and may have a
protective cover over the microprocessor. Do not use the tool, or remove the cover until you are
instructed to do so.
Note: Be sure to use the installation tool that comes with your microprocessor installation tool assembly.
The tool has two settings for installing two different sizes of microprocessors. The settings that are marked
on the tool are "L" for smaller low core microprocessors, and "H" for larger high core microprocessors.
Figure 83. Microprocessor installation tool
To remove a microprocessor and heat sink, complete the following steps:
Step 1. Read the safety information that begins on "Safety" on page v and "Installation guidelines" on
page 100.
Step 2. Turn off the server and peripheral devices and disconnect all power cords.
Step 3. Remove the cover (see "Removing the cover" on page 104).
Step 4. Remove the air baffle (see "Removing the air baffle" on page 106).
Step 5. Locate the microprocessor to be removed (see "System-board internal connectors" on page 22).
Step 6. Remove the heat sink.
Attention: Do not touch the thermal material on the bottom of the heat sink. Touching the thermal
material will contaminate it. If the thermal material on the microprocessor or heat sink becomes
contaminated, you must wipe off the contaminated thermal material on the microprocessor or heat
sink with the alcohol wipes and reapply clean thermal grease to the heat sink.
a. Use a screwdriver to loosen the captive screw on one side of the heat sink to break the seal
with the microprocessor.
b. Loosen all the captive screws on the heat sink, rotating each screw one full turn until each
screw is loose.
Installation tool
Microprocessor
Microprocessor Installation Tool
.
Chapter 5 Removing and replacing components
157