Replacing An Adapter - Lenovo HX1310 Installation And Service Manual

Step 6. Carefully grasp the adapter by its top edge or upper corners, and pull the adapter from the PCI
riser-card assembly.
Figure 49. Adapter removal from a PCI riser-card assembly that has one low-profile slot (for PCI riser-card
assembly connector 1 on system board)
Figure 50. Adapter removal from a PCI riser-card assembly that has one low-profile slot and one full-height
half-length slot (for PCI riser-card assembly connector 2 on system board)
If you are instructed to return the adapter, follow all packaging instructions, and use any packaging materials
for shipping that are supplied to you.

Replacing an adapter

The following notes describe the types of adapters that the server supports and other information that
you must consider when you install an adapter.
• Locate the documentation that comes with the adapter and follow those instructions in addition to
the instructions in this section.
• Do not set the maximum digital video adapter resolution above 1600 x 1200 at 75 Hz for an LCD monitor.
This is the highest resolution that is supported for any add-on video adapter that you install in the server.
• Any high-definition video-out connector or stereo connector on any add-on video adapter is not supported
• The server does not support full-length, full-height PCI adapters or legacy 5V PCI adapters.
• When you install any PCI adapter, the power cords must be disconnected from the power source before
you remove the PCI Express riser-card assembly. Otherwise, the active power management event signal
will be disabled by the system-board logic, and the Wake on LAN feature might not work. However, after
126
HX1310, HX2310-E, HX3310, HX3310-F Installation and Service Guide
Adapter
Adapter
Expansion
filler
Expansion
filler
Adapter
Expansion
filler