Replacing The Cover - Lenovo HX1310 Installation And Service Manual

Step 5. Press the blue tab on the cover-release latch and lift up the cover-release latch. Then, slide the
cover to the rear.
Figure 29. Cover removal
Step 6. Lift the server cover off the server and set it aside.
Attention: For proper cooling and airflow, replace the server cover before you turn on the server.

Replacing the cover

Use this information to replace the cover.
To replace the server cover, complete the following steps:
Step 1. Make sure that all cables, adapters, and other components are installed and seated correctly
and that you have not left loose tools or parts inside the server. Also, make sure that all internal
cables are correctly routed.
Important: Before you slide the cover forward, make sure that all the tabs on the front, rear, and
side of the cover engage the chassis correctly. If all the tabs do not engage the chassis correctly, it
will be very difficult to remove the cover later.
Step 2. Position the cover on top of the server.
Step 3. Slide the cover toward the front of the server.
Step 4. Make sure that the cover correctly engages all the inset tabs on the server.
Cover
Latch
.
Chapter 5 Removing and replacing components
105