Table of Contents
Advertisement
Step 2.
Align the EIA bracket with the pin on the chassis; then, press the bracket onto the chassis and
slightly slide it leftward.
Figure 36. EIA bracket installation
Step 3.
Install the screws to secure the EIA bracket to the chassis.
Note: Use the T8 torx wedge to install the screws.
Figure 37. Screw installation
Step 4.
Slide the server back into the rack until it latches.
Step 5.
Reconnect the external cables and power cords, if necessary.
Removing and replacing Tier 1 CRUs
Replacement of Tier 1 CRUs is your responsibility. If Lenovo installs a Tier 1 CRU at your request, you will
be charged for the installation.
The illustrations in this document might differ slightly from your hardware.
110
HX1310, HX2310-E, HX3310, HX3310-F Installation and Service Guide
EIA bracket
Advertisement
Table of Contents
Troubleshooting
