Table of Contents
Advertisement
Figure 69. Front video connector assembly removal for eight 2.5-inch hot-swap hard disk drive server
configuration
Step 6.
If you are instructed to return the front video connector assembly, follow all packaging instructions,
and use any packaging materials for shipping that are supplied to you.
Replacing the front video connector assembly
Use this information to replace the front video connector assembly.
To install the front video connector assembly, complete the following steps:
Step 1.
Read the safety information that begins on "Safety" on page v and "Installation guidelines" on
page 100.
Step 2.
From inside the media cage, insert the front video connector assembly into the holes on the cage;
then, install the screws to secure the assembly to the cage.
Figure 70. Front video connector assembly installation for eight 2.5-inch hot-swap hard disk drive server
configuration
Media cage
Screws
Media cage
Screws
Video connector
Video connector
.
Chapter 5
Removing and replacing components
147
Advertisement
Table of Contents
Troubleshooting
