Oil Pump Assembly; Counter Balancer Shaft Removal/Inspection - Polaris 2007 Sportsman 500 EF Service Manual

Atv polaris 2007 sportsman 450 / 500 efi / 500 x2 efi
Table of Contents

Advertisement

ENGINE
9.
Measure pump end clearance using a feeler gauge and
straight edge.
Pump End Clearance:
Std: .001 -.003 (.0254-.0762 mm)
Wear Limit: .004 (.1016 mm)
10. Measure clearance between outer feed rotor and pump body
with a feeler gauge.
Rotor Tip Clearance:
Std: .005 (.127 mm)
Wear Limit: .008 (.2032 mm)
11. Measure rotor tip clearance with a feeler gauge.
12. Remove inner and outer feed rotor and pump chamber
body.
13. Repeat measurements for scavenge rotor.
14. Remove inner and outer scavenge rotor and inspect pump
shaft for wear.
3.34

Oil Pump Assembly

1.
Clean and dry all parts thoroughly. Apply clean engine oil
to all parts. Do not use gasket sealer on the pump body
mating surfaces or oil passages will become plugged.
2.
Install pump shaft and scavenge rotor drive pin.
3.
Install outer scavenge rotor, inner scavenge rotor, and
scavenge casing.
4.
Install outer feed rotor and inner feed rotor drive pin.
5.
Install inner feed rotor and feed chamber cover with screw.
6.
Tighten screw securely.
7.
Install screen on pump body.
8.
Install oil pump on crankcase and torque bolts to 6 ft. lbs.
(8 Nm).
Oil Pump Attaching Bolt Torque:
6 ft. lbs. (8 Nm)

Counter Balancer Shaft Removal/Inspection

1.
Remove the shim washer (A) from the counter balancer
shaft.
A
2.
Note the alignment dots on the balancer and crankshaft
gears, the marks must be aligned during reassembly.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents