Registering The Rt-B(Hsu); Basic Configuration For Operations; Figure 6-3 Main Window : Link - Radwin 2000+ SERIES User Manual

Registering the RT‐B(HSU)
Observe that under management mode (no traffic) the throughput and MCS is min‐
imal to support a link and the CBW is also at its minimum for DBS.
12. If you are using Local Connection, log out and log back in to the RT‐A(HBS) on its IP
address.
You may have observed that operating frequency 5.770 GHz shown, is not what we chose
(5.820 GHz). The RT‐A(HBS) tries to optimize the frequency to minimize interference effects.
We next register and configure the RT‐B(HSU). Many of the configuration and service
parameters may be set prior to registration. During link establishment the order does not
matter. However, many configuration changes to a link after registration, will affect traffic or
even reset the link.
6.2.3 Registering the RT‐B(HSU)
After few moments, the registration process completes. Here is the status of the link:
Figure 6‐3: Main window: Link Master ODU activated, Slave ODU registered
6.2.4 Basic Configuration for Operations
Several basic parameters should be configured for both link sites. Use the appropriate site
Configuration button:
RADWIN 2000+ Series User Manual Release 4.2.40 6‐12