Tools Required for Installation
4.4 Tools Required for Installation
The following is a list of the equipment and materials required to install RADWIN 2000+ Series
hardware.
4.4.1 Tools and Materials
•
Crimping tool for RJ‐45 (if the ODU‐PoE cable is without connectors)
•
Spanner/wrench 13 mm (½")
•
Drill (for wall mounting only)
•
Cable ties
•
Sealing material
•
Waterproofing tape such as Scotch 23 Tape ¾" wide, from 3M to ensure IP‐67 compliant
protection against water and dust
4.4.2 Cables and connectors
•
ODU grounding cable 10 AWG
•
ODU‐PoE cable (outdoor class, CAT‐5e, 4 twisted pairs, 24AWG):
• Up to 100 m. for 100BaseT connection.
• For a 1000BaseT connection (HBS only) use an ODU‐PoE cable no longer than 75m.
For 1000BaseT, you should use RADWIN supplied ODU‐PoE cables, which
guarantees 1Gb performance. RADWIN cannot guarantee 1Gb
performance if you use third party cables.
• External CAT‐5e cable diameter should be between 7‐9 mm to ensure waterproof
sealing.
4.5 Unpacking and Checking
For each item:
1. Remove the equipment from the box.
2. Check that everything listed on the included Bill of Materials or Pro‐forma Invoice is
present.
3. If any item is missing, contact Customer Service. You will be advised whether to
return the package for replacement, or whether the missing item can be supplied
separately.
4. Do not dispose of the packaging until the unit is installed and operational.
RADWIN 2000+ Series User Manual
Release 4.2.40
4‐11