Figure 7-5 Supported Protocols - Radwin 2000+ SERIES User Manual

Management
ported by the radio unit (ICMP, SNMP, Telnet and NTP). Using VLAN for management
traffic affects all types of management connections (local, network and over the
air).
3. Enter a Priority number between 0 and 7.
The VLAN priority is used for the traffic sent from the ODU to the managing com‐
puter.
4. Change the VLAN ID and Priority of the managing computer NIC to be the same as
those of steps 2 and 3 respectively.
5. Click Apply or OK.
Lost or forgotten VLAN ID
If the VLAN ID is forgotten or there is no VLAN traffic connected to the ODU, then reset the
relevant ODU.
If the managing computer is directly connected to an ODU, and you enable
management VLAN, you will lose connectivity. To log on again, You will
need to configure the managing computer NIC to use the management
VLAN number.
During the first two minutes of connection, the ODU uses management
packets both with and without VLAN. You may use this period to
reconfigure the VLAN ID and priority.
Supported Protocols
Supported protocols are shown in Figure
Figure 7‐5: Supported protocols
SNMP support is permanently enabled. You may choose between SNMPv1, SNMPv3 or both.
If you choose SNMPv3, you will be offered the following cautionary message:
RADWIN 2000+ Series User Manual
7‐5:
Release 4.2.40 7‐10