Figure 4-53 Installing An Lpu - Radwin 2000+ SERIES User Manual

Lightning Protection Unit (LPU) for CAT‐5e Cables
Figure 4‐53: Installing an LPU on a pole (side view)

To install an LPU on a wall:
1. Remove the grounding lug.
2. Attach the LPU to the wall using wood or masonry screws (not included), via the
holes as shown in Figure
3. Connect the left screw (where the grounding lug was located) to a ground source.
4. Remove the cable glands.
5. Thread the CAT‐5e cables through the cable glands, and connect the cables to the
LPU as shown in Figure
6. Tighten the cable glands around the CAT‐5e cables as shown in Figure
7. Route one CAT‐5e up to the ODU (via the upper LPU), and the other to the IDU or
PoE.
8. RADWIN recommends that you add extra waterproofing to the connections
(see Additional Considerations for Waterproofing on page 4‐38).
RADWIN 2000+ Series User Manual
4‐54.
4‐51.
Release 4.2.40
4‐52.
4‐37