Configuration With Telnet; Telnet Access To Either Odu; Figure 6-14 Telnet Session Log - Radwin 2000+ SERIES User Manual

Configuration with Telnet
6.4 Configuration with Telnet
6.4.1 Telnet Access to Either ODU
A Telnet terminal can be used to configure and monitor the RADWIN 2000+ Series radio units.
To start a Telnet session on the RT‐A(HBS), use telnet <ODU_IP>.
For example, if you run Telnet as follows,
telnet 10.104.3.2
you will be asked for a user name and password.
The Telnet log on user name is the password that you used to enter the RADWIN Manager
(for example, the default: admin). The Telnet password is the corresponding Community
string (default: netman).
Figure 6‐14: Telnet session log on to the RT‐A(HBS)
A Read‐Only Community string allows you to use display commands only whereas a Read‐
Write Community string allows you to use display commands and execute set commands.
Supported radio unit (ODU) Telnet commands are shown in Table 6‐2 to Table
to both RT‐A(HBS) and RT‐B(HSU)
Table 6‐2: ODU Telnet ‐ Display Commands
Command
display inventory
display management
display link
display ethernet
display ethernet_errors
display ntp
RADWIN 2000+ Series User Manual
Explanation
Displays radio unit product name, Name, Location,
hardware and software revisions, uptime, MAC
address.
Displays IP, subnet, Gateway, Traps table
Displays all static details about the link
Displays Port table (State, Status and action)
Displays Cable statistics
Displays Time, Server and Offset
Release 4.2.40
6‐4. They apply
6‐28