Configuring the RT‐A(HBS) as an HSS master
Figure 11‐2: Extended Protocol Parameters for HSSoE
4. Set the Operation state as Hub Sync Master. Later, we will need one of the client
options for the collocated site.
5. Set the Protocol as Ethernet.
6. The Domain is the HSS domain and refers to the current hub site. It is used to
distinguish between hub sites to prevent inadvertent collocation to an over‐the‐air
unit. We set it as shown, to PM_Lab.
7. Leave the VLAN ID as is at 1977 unless there is some reason to change it.
8. The Discovery options are as follows:
Figure 11‐3: HSS discovery filters
RADWIN 2000+ Series User Manual
Release 4.2.40
11‐6