Preferences: Monitor; Figure 5-11 Monitorp - Radwin 2000+ SERIES User Manual

Preferences: Monitor
5.8.1 Preferences: Monitor
Figure 5‐11: Monitor Preferences
File: Place a checkmark here to save traffic and identification information to the Monitor
file. The content of the Monitor file is described in detail in
and Diagnostics.
Click the explorer button
Click the select headers button
in the Monitor file.
From the screen that appears, place a checkmark next to each category of data
you wish to be saved in the Monitor file
Interval:Save the data every X seconds to the Monitor file (and the Utilization file if relevant).
X can be an integer value only, and from 1 to 60. This file can be very large very
quickly, so if you want to store data for a lengthy period of time, choose a large
number.
The KMZ button is not functional here and can be ignored.
Rx/Tx Rate Units: Choose Mega bits per second (Mbps), or Frames per second (Fps)
Show IP:Determine which IP address format to show on the main window for each unit: IPv4
or IPv6. The IPv6 option will work only if you have defined an IPv6 address for the
unit.
IPv6 Address Format: If showing IPv6 addresses, choose Compressed or Expanded.
1. There may be categories listed that are not relevant for the specific radio model you are working with. Ignore
those categories.
RADWIN 2000+ Series User Manual
to select the location of this file.
to select the categories of data to be saved
1
. Click OK to accept your choices.
Release 4.2.40
Chapter 8, Monitoring
5‐15