Outdoor units and antennas should be installed ONLY by experienced
installation professionals who are familiar with local building and safety
codes and, wherever applicable, are licensed by the appropriate
government regulatory authorities. Failure to do so may void the product
warranty and may expose the end user or the service provider to legal and
financial liabilities. Resellers or distributors of this equipment are not
liable for injury, damage or violation of regulations associated with the
installation of outdoor units or antennas. The installer should configure
the output power level of antennas according to country regulations and
antenna type.
•
•
(2) These devices must accept any interference received, including interference that may
cause undesired operation.
Canadian Emission Requirements for Indoor Units
This Class B digital apparatus complies with Canadian ICES‐003.
Cet appareil numẻrique de la classe B est conforme ả la norme NMB‐003 du Canada.
China MII
Operation of the equipment is only allowed under China MII 5.8GHz band regulation
configuration with EIRP limited to 33 dBm (2 Watt).
India WPC
Operation of the equipment is only allowed under India WPC GSR‐38 for 5.8GHz band
regulation configuration.
Unregulated
In countries where the radio is not regulated the equipment can be operated in any
regulation configuration, best results will be obtained using Universal regulation
configuration.
Safety Practices
Applicable requirements of National Electrical Code (NEC), NFPA 70; and the National
Electrical Safety Code, ANSI/IEEE C2, must be considered during installation.
RADWIN 2000+ Series User Manual
Where Outdoor units are configurable by software to Tx power val‐
ues other than those for which the product is certified, it is the
responsibility of the Professional Installer to restrict the Tx power to
the certified limits.
This product was tested with special accessories ‐ indoor unit (IDU or
PoE), FTP CAT‐5e shielded cable with sealing gasket, 10 AWG ground‐
ing cable ‐ which must be used with the unit to insure compliance.
Release 4.2.40
6‐2